|
| |
TM 5-4320-305-24
2-39. REPLACE/REPAIR TAILLIGHTS AND CLEARANCE LIGHTS (Continued)
INSPECTION/REPAIR:
1 Inspect taillights and clearance lights for rust, dents, or other exterior damage. Replace damaged light.
2 Inspect bulbs for broken filaments, corroded bases, broken or discolored envelopes. Replace damaged bulbs.
3 Inspect connecting wires for breaks or deteriorated insulation. Replace if necessary.
4 Inspect lenses for cracks or brittleness. Replace if necessary.
5 Check that reflectors are securely in place and not damaged. Replace broken reflector.
INSTALLATION:
1 Install two bulbs (13) in each clearance light (14).
2 Position clearance lights (14) on trailer frame (7) and install screw (15), lockwasher (16), and nut (17).
3 Install lens (12) on clearance light (14) with two mounting screws (11).
4 Connect clearance light wires (18) to trailer wiring harness (9) at connectors (10).
5 Position taillight (4) on outside of frame assembly and install nuts (5) and lockwashers (6) from inside of frame
assembly (7).
6 Install bulbs (3) in taillights (4).
7 Install lens (1) on taillight (4) with mounting screws (2).
8 Connect taillight wires (8) to trailer wiring harness (9) at connectors (10).
WARNING
Death or serious injury could occur if diesel fuel oil is not handled
carefully. Use in a well-ventilated area away from open flame,
arcing equipment, ignition sources, heaters, or excessive heat.
Always store fuel in proper, marked containers. DO NOT SMOKE.
9 Clean trailer frame mounting surface with diesel fuel oil and install reflectors (20) with sealing compound.
2-147
|
