|
| |
TM 5-4320-305-24
2-34. TEST/REPLACE STARTER MOTOR
This task covers:
a. Removal
c. Installation
b. Test/Inspection
d. Operational Check
INITIAL SETUP
Tools
Equipment Condition
Shop equipment, automotive maintenance
Para
Condition Description
and repair, common no. 1
2-13
Engine shut down and cool.
Battery cables removed.
Tool kit, general mechanics automotive
2-15
Starter electrical system
wiring removed.
REMOVAL:
1 Support starter (1) and remove three bolts (2) and
three washers (3).
2 Remove starter (1) with relay (4) attached.
TEST/INSPECTION:
Remove relay and starter. Test and inspect relay. If relay
does not activate when excited with ground and +24 vdc
from 24 vdc power supply, the unit is not operating
properly. Test starter with ground and +24 vdc. Replace
starter motor if necessary.
INSTALLATION:
1 Support starter (1) and relay (4) and install three
bolts (2) and three washers (3). Tighten bolts (2)
securely.
2 Install tagged electrical system wires and positive
battery cable in accordance with paragraphs 2-15
and 2-13. Tighten lug nuts securely.
3 Install negative battery cable. Tighten lug nuts
securely.
2-129
|
