|
| |
TM 5-4320-305-24
2-24. REPLACE/REPAIR THROTTLE ACTUATOR, QUICK RELEASE LINK, AND MAGNETIC
PICKUP (Continued)
7
Place the rear end bore of quick release link over the actuator arm bore. If the two bores are not aligned, adjust
the position of the actuator arm on the actuator shaft. Loosen nut (10) so that the actuator arm can turn freely on
the actuator shaft. Rotate the actuator arm to a position so that the rear end bore and actuator arm bore are
aligned. Tighten nut (10) to secure the actuator arm to the actuator shaft.
8
Install bolt (6) through actuator arm bore and quick release link bore.
9
Install washer (5) and nut (4) onto bolt (6).
2-101
|
