|
| |
TM 5-4320-305-10
2-15.
EMERGENCY PROCEDURES (Continued)
maximum rate. Turning the MANUAL THROTTLE
CONTROL knob to the left increases engine speed.
Turning it to the right decreases engine speed. As
engine speed is increased and decreased, the pump
output and discharge pressure are increased and
decreased proportionally. The retrofit kit is stored in the
trailer tool box.
NOTE
Engine speed can also be adjusted
by pressing button located in center
of MANUAL THROTTLE CONTROL
knob. Pulling out knob increases
speed. Pushing in decreases speed.
a.
Retrofit kit installation. When retrofit kit installation is necessary, proceed as follows:
(1)
Pull out the throttle knob until the far end of cable (1) with ball joint (2) retracts toward the quick
disconnect attachment point.
(2)
Push ball joint end of cable through
the two split grommets on the floor of
panel
and
support
plate
below
allowing cable to feed into space
under panel.
(3)
Route throttle cable per illustration.
(4)
Fasten panel in place with screw.
(5)
Push in throttle cable knob.
(6)
Disconnect actuator linkage (4) in
middle of rod. Rotate front part of
linkage counter-clockwise and allow to
hang down.
(7)
Insert ball joint of throttle cable into
small hole of throttle lever (3) and
secure with lockwasher and nut.
(8)
Plug
throttle
cable
quick
attach
assembly (5) into mating fitting on
engine bracket. Secure collar on
anchoring assembly. Check for lock
engagement.
(9)
Check movement of manual throttle
control.
2-83
|
