|
| |
TM 5-4320-304-14
TM 08922A-14/1
4-7. PRELIMINARY SERVICING AND ADJUSTMENT OF EQUIPMENT SETUP (Continued)
Do not overfill. Engine damage could result.
If oil coating IS below top mark (2), remove oil cap (3) and add oil of proper viscosity required by
ambient temperature. See following chart.
Again check oil level to be sure oil coats dipstick (1) to top mark (2). Check that cap is tightly closed.
If oil coating extends above top mark, loosen drain plug (1), drain enough oil to lower oil level to
top mark on dipstick, then tighten drain plug securely.
c. Refer to table 4-1 and perform preventive maintenance checks and services.
4-4
|
