|
| |
TM 5-4320-304-14
TM 08922A-14/1
6-6. REPLACE OIL SEAL (FLYWHEEL SIDE) (Continued)
CLEANING/lNSPECTION:
Death or serious injury could occur if fuel is not handled
carefully. Use in a well-ventilated area away from open
flame, arcing equipment, ignition sources, heaters, or exces-
sive heat. Always store fuel in proper, marked containers.
DO NOT SMOKE.
Death or serious injury could occur if compressed air is
directed against the skin. Do not use compressed air for
cleaning or drying unless the pressure is/has been reduced
to 30 psi (2.06 bar) or less. When working with com-
pressed air, always use chip guards, eye protection, and
other personal protective equipment.
1
Clean oil seal components with diesel fuel and dry with compressed air.
2
Inspect all components for damage or excessive wear. Replace any components severely damaged
or worn.
INSTALLATION:
1
Install auxiliary bush 666 068 00 in crankshaft.
2
Install oil seal (5) into support (1).
3
Fill groove of oil seal (5) with grease.
4
Lubricate new preformed packing (4) with grease and install it in preformed packing groove in
support (1).
5
Install support (1) onto crankshaft with two security plates (2) and four hex screws (3).
6
Remove auxiliary bush 666 068 00.
6-20
|
