|
| |
TM 5-4320-304-14
TM 08922A-14/1
5-13. lNSPECT/REPLACE/REPAIR FLYWHEEL (Continued)
REPAIR:
Death or serious injury could occur if fuel is not handled
carefuIly. Use in a well-ventilated area away from open
flame, arcing equipment, ignition sources, heaters, or exces-
sive heat. Always store fuel in proper, marked containers.
DO NOT SMOKE.
Death or serious injury could occur if compressed air is
directed against the skin. Do not use compressed air for
cleaning or drying unless the pressure is/has been reduced
to 30 psi (2.06 bar) or less. When working with com-
pressed air, always use chip guards, eye protection, and
other personal protective equipment.
1
Smooth out nicks or burrs on flywheel and blower ring. Remove rust or corrosion, then clean
with diesel fuel oil.
2
Dry with compressed air.
INSTALLATION:
1
2
3
4
5
6
7
8
9
Align blower ring (9) holes with mounting holes on flywheel (1).
Install three spring washers (8) and three screws (7).
Using socket 612 099 00, tighten screws to 22.13 foot-pounds
Install four screws (5) and spring washers (6) through flywheel
Restrain fIywheel.
Tighten screws to 51.6 foot-pounds (70 N·m).
Take restraint off flywheel. Make sure flywheel turns freely.
(30 N·m).
(1) and into engine crankshaft.
Install stub shaft (4), with three spring washers (3) and three screws (2).
Install engine adapter housing.
5-46
|
