|
| |
TM 5-4320-304-14
TM 08922A-14/1
Section II.
Crank assembly gears
C y l i n d e r
Cylinder head and valve
assembly
Engine assembly
FIywheel
5-3. GENERAL INSTRUCTIONS
MAINTENANCE
INDEX
Para
PROCEDURES
Para
5-9
Frame assembly
5-14
5-11
Injection pump
5-8
5-10
Injector
5-7
Lift pump
5-6
5-5
Piston
5-12
5-13
Pump case
5-4
Most maintenance instructions in this section will list resources required, personnel required, and equip-
ment condition for the start of the procedure. Note the following:
l Resources required are not listed unless they apply to the procedure.
l Personnel required are listed only if the task requires more than one. If PERSONNEL is not
listed, it means one person can do the task.
l The normal standard equipment condition to start a maintenance task is engine stopped. EQUIP-
MENT CONDITION is not listed unless some other condition is required.
l Refer to Appendix F to determine torque requirements when tightening threaded fasteners,
unless a specific torque value is given in procedure. Standard torque values given in Appendix F are
determined by thread size.
5-3
|
