Click here to make tpub.com your Home Page

Page Title: Reassembly and Installation-continued
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM
5-4320-273-14
space is leas than required, remove the impeller and
bracket (23) and install the intermediate bracket on
add shims to desired width when impeller is rein-
the engine, taking care not to dislodge the stationary
stalled.
seal members. Secure the bracket to the engine with
(6) Install a new gasket (33) on the intermediate
screws (27 and 28) and lockwasher (13).
bracket. Using a hoist, slide pump casing (15) into
CAUTION
position on the intermediate bracket. Install lifting
The mating faces of the pump seal are
bail (6). Secure the casing with nuts (21) and lock-
highly machined and are easily
washers (22).
damaged by rough handling a n d
(7) Without resetting the oil pressure safety
careless installation. Take care when
switch to prevent the engine from starting, crank the
you install seal parts or pump failure
engine to ensure that the pump turns freely without
may result.
scraping or binding.
(3) Coat the face of the rotating seal member and
(8) Install cleanout cover (19) and gasket (20)
using nut (2) and washer (8).
the shaft sleeve with light engine oil. Install the
(9) Install O.P.W. fitting, adapter (18), gasket
rotating parts of the seal on the shaft sleeve. Coat
the end of the engine crankshaft sparingly with light
(17), and dust cap (16).
(10) Install discharge elbow (8) and gasket (11)
engine oil and install the shaft sleeve (25), with
using nuts (9) and lockwashers (10).
rotating seal parts, onto the crankshaft. Push until
(11) Secure lifting bail (6) and support (7) to
sleeve is firm against shoulder on crankshaft.
(4) Install the impeller (24) on the engine crank-
discharge elbow using nuts (2) and washers (3 and 4).
shaft without shims, Note that the impeller has a
(12) Reassemble the components and piping
removed to enable pump disassembly, Replace pump
right hand thread.
(5) With the impeller firmly seated on the shaft,
suction piping assembly, discharge piping assembly,
measure the space between the back of the impeller
and the instrument control panel. Replace air
and the face of the intermediate (fig. 7-2). If the
eliminator.
7-4

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business