|
|
TM 5-4320-258-20P
Section I.
INTRODUCTION
1.
Scope
Code
Explanation
This manual lists repair parts required for the
performance of organizational maintenance of the
M
Repair Parts, Special Tools and Test
pump.
Equipment which are not procured or
stocked, as such, in the supply system
2.
General
bust are to be manufactured at indicated
This Repair Parts and Special Tools List is divided into
maintenance levels.
the following sections:
A
Assemblies which are not procured or
stocked as such, but are made up of two
or more units.
Such component units
number sequence, of repair parts authorized at the
carry individual stock numbers and
organizational
level
for
the
performance
of
descriptions, are procured and stocked
maintenance, including those items which must be
separately and can be assembled to form
removed for replacement of the authorized item. Items,
.the required assembly at indicated
except kits and sets, are listed by assembly group in top
maintenance categories.
down breakdown sequence. Repair parts kilts and sets
X
Parts and assemblies that are not procured
are listed separately as Group 39 at the end of the
or stocked because the failure rate is
Repair Parts List without regard to the assembly group
normally below that of the applicable end
to which they belong. Components of the kits and sets
item or component. The failure of such a
are listed in their proper sequence in the assembly
part or assembly should result in
group to which they belong and are referenced to the
retirement of the end item from the supply
FSN of the kit or set.
system.
b. Special Tools, Test and Support Equipment-
X1
Repair Parts which are not procured or
Section III. (Not Applicable).
stocked. The requirement for such items
will be filled by the next higher assembly
c. Federal Stock Number and Reference Number
or component.
X2
Repair Parts, Special Tools, and Test
ascending numerical sequence followed by a list of
Equipment which a-re not stocked and
reference numbers in ascending alpha-numeric
have no foreseen mortality.
The
sequence, cross-,referenced to the illustration figure
indicated maintenance category requiring
number and item number.
such repair parts will attempt to obtain the
parts through cannibalization or salvage,
3.
Explanation of Columns The following provides
the item may be requisitioned with
an explanation of columns in the tabular lists in Sections
exception data, from the end item
manager, for immediate use.
G
Major assemblies that are procured with
a. Source, Maintenance, and Recoverability Codes
PEMA funds for initial issue only as
(SMR):
exchange assemblies at DSU and GISU
(1) Source code indicates the selection status
level.
These assemblies will not be
and source for the listed item. Source codes are:
stocked above the DS and GS level or
returned to depot supply level.
Code
Explanation
Note
Cannibalization or salvage may be
P
Repair Parts, Special Tools and Test
used as a source of supply for
Equipment supplied from the GSA/DSA,
any items source coded above
or Army supply system, and authorized for
except those coded X1 and
use at indicated maintenance categories.
aircraft
support
items
as
P2
Repair Parts, Special Tools and Test
restricted by AR 700-42.
Equipment which are procured and
stocked for insurance purposes because
the combat or military essentiality of the
(2) Maintenance
code
indicates
the
end item dictates that a minimum quantity
lowest category of maintenance authorized to install the
be available in the supply system.
listed item.The maintenance level code is:
Code
Explanation
C
Crew or operator
O
Organizational maintenance
iii
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |