APPENDIX C. BASIC ISSUE ITEMS LIST - TM-5-4320-258-120081

APPENDIX C

BASIC ISSUE ITEMS LIST

SECTION I. INTRODCUTION

Code

Explanation

C-1. Scope

This appendix lists items which accompany

which are not procured or stocked, as

the pump or are required for installation, operation,

such, in the supply system but are to be

or operator's maintenance.

Repair Parts and

manufactured at indicated maintenance

Special Tools assigned maintenance code "C" in

levels.

the organizational portion of the Maintenance

Assemblies which are not procured or

Repair Parts and Special Tools List Manuals, may

stocked as such, but are made up of

be stocked at the operator level of maintenance

two or more units. Such component

when authorized by the Unit Commander.

units carry individual stock numbers

and descriptions, are procured and

stocked separately and can be

C-2. General

assembled to form the required

This Basic Issue Items List is divided into the

assembly at indicated maintenance

following sections:

categories.

Parts and assemblies that are not

a. Basic Issue Items-Section II. A list of items

procured or stocked because the

failure rate is normally below that

which accompany the pump and are required by

of the applicable end item or

the crew/operator for installation, operation, or

component. The failure of such

maintenance.

part of assembly should result in

b. Maintenance and Operating Supplies-

retirement of the end item from the

Section III. A listing of maintenance and operating

supply system.

supplies required for initial operation.

Repair parts which are not procured or

stocked. The requirement for such

items will be filled by use of the next

C-3. Explanation of Columns

higher assembly or component.

Repair parts, Special Tools and Test

The following provides an explanation of

Equipment which are not stocked

columns in the tabular list of Basic Issue Items,

and have no foreseen mortality.

Section II.

The indicated maintenance category

requiring such repair parts will

attempt to obtain the parts through

a. Source, Maintenance, and Recoverability

cannibalization or salvage, if not

Codes (SMR):

obtainable through cannibalization

or salvage, the item may be

(1) Source code indicates the source for

requisitioned with exception data,

the listed item. Source codes are:

from the end item manager, for

immediate use.

Major assemblies that are procured

Code

Explanation

with PEMA funds for initial issue

only as exchange assemblies at

Repair parts, Special Tools and Test

DSU and GSU level. These

Equipment supplied from the

assemblies will not be stocked

GSA/DSA, or Army supply system

above DS and GS level or returned

and authorized for use at indicated

to depot supply level.

maintenance categories.

Note. Cannibalization or salvage may be used as

Repair parts, Special Tools and Test

a source of supply for any items source coded above

Equipment which are procured and

except those coded X1 and aircraft support items as

stocked for insurance purposes

restricted by AR 700-42.

because the combat or military

(2) Maintenance code indicates the lowest

essentially of the end item dictates

category of maintenance authorized to install the listed

item. The maintenance level code is:

that a minimum quantity be

Code

Explanation

available in the supply system.

Repair parts, Special Tools and Test

C -----------------------Crew/Operator

Equipment

(3) Recoverability code indicates whether

unserviceable items should be returned for recovery or

salvage.

Items not coded are nonrecoverable.

Recoverability

codes

are:

C-1