| |
- OPERATOR AND ORGANIZATIONAL MAINTENANCE MANUAL FOR PUMP, CENTRIFUGAL, POL, GED, 6 IN., 1120 GPM SKID-MOUNTED (BARNES MODEL US67CCG)
- WARNING
- Operator and Organizational Maintenance Manual is changed s follows
- Operator and Organizational Maintenance Manual is changed s follows
- Explanation of Columns
- Section III. BASIC ISSUE ITEMS
- Section II. EXPENDABLE SUPPLIES AND MATERIALS LIST
- Operator and Organizational Maintenance Manual is changed as follows
- Operator and Organizational Maintenance Manual is changed as follows
- Operator and Organizational Maintenance Manual is changed as follows
- Table of Contents
- LIST OF ILLUSTRATIONS
- CHAPTER 1. INTRODUCTION
- Figure 1-1. Centrifugal pump, left front view.
- Figure 1-2. Centrifugal pump, right rear view.
- Figure 1-3. Engine wiring diagram.
- CHAPTER 2. OPERATING INSTRUCTIONS
- Section II. MOVEMENT TO A NEW WORKSITE
- Table 2-1. Controls and Instruments
- Figure 2-3. Miscellaneous controls, indicators, and plugs.
- Figure 2-4. Fuel tank and related parts.
- Section IV. OPERATION UNDER USUAL CONDITIONS
- Starting
- Section V. OPERATION UNDER UNUSUAL CONDITIONS
- Operation in Sandy or Dusty Areas
- CHAPTER 3. OPERATOR'S MAINTENANCE INSTRUCTIONS
- Section IV. TROUBLESHOOTING
- Table 3-2. Troubleshooting Chart-continued
- CHAPTER 4. ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
- Section II. DESTRUCTION OF MATERIEL TO PREVENT ENEMY USE
- Engine Lubrication
- Pump Lubrication
- Table 4-1. Preventive Maintenance Checks and Services-continued
- Table 4-1. Preventive Maintenance Checks and Services-continued
- Section VIII. MAINTENANCE OF AIR CLEANER, EXHAUST SYSTEM, AND ENGINE HOUSING
- Figure 4-4. Air cleaner, exploded view
- Figure 4-5. Air cleaner and piping, exploded view.
- Figure 4-6. Muffler and piping, exploded view.
- Figure 4-7. Engine housing, exploded view
- Section IX. MAINTENANCE OF FUEL SYSTEM
- Fuel Strainer, Fuel Lines, and Fittings
- Figure 4-11. Fuel system components, exploded view.
- Carburetor
- Engine Speed Governor
- Figure 4-13. Magneto and governor installation.
- Figure 4-14. Primer pump, lines, and fittings, exploded view.
- Section X. MAINTENANCE OF COOLING SYSTEM
- Thermostat, Outlet Elbow, Lines, and Fittings
- Figure 4-17. Thermostat, outlet elbow, coolant and oil cooler lines and fittings, exploded view.
- Figure 4-18. Alternator mounting.
- Section XI. MAINTENANCE OF IGNITION SYSTEM
- Spark Plugs
- Figure 4-21. Ignition system, exploded view.
- Figure 4-22. Magneto-to-spark plug connections.
- Figure 4-23. Magneto, exploded view.
- Figure 4-24. Timing marks on distributor gear and rotor shaft.
- Section Xll. MAINTENANCE OF ELECTRICAL SYSTEM
- Figure 4-26. Right side of engine, showing components.
- Figure 4-27. Electrical system setup for battery voltage and isolation diode test.
- Figure 4-28. Field current draw test setup.
- Figure 4-29. Voltage regulator operating voltage test setup.
- Figure 4-30. Alternator output and system test setup.
- Figure 4-31. Battery charging system, exploded view.
- Voltage Regulator
- Reverse Polarity Protector
- Figure 4-34. Engine starter brushes, exploded view.
- Section XIII. MAINTENANCE OF CONTROLS AND INSTRUMENTS
- Figure 4-36. Control panel engine controls and instruments, exploded view.
- Suction and Discharge Gages, Lines, and Fittings
- Figure 4-38. Suction and discharge gages, lines, and fittings, exploded view.
- Section XIV. MAINTENANCE OF PUMP AND
- Flexible Coupling
- Section XV. ENGINE TESTING
- Engine Compression Test
- APPENDIX A. REFERENCES
- APPENDIX B. MAINTENANCE ALLOCATION CHART
- Explanation of Columns in Section III,
- Section II. MAINTENANCE ALLOCATION CHART
- Section III. REMARKS
- APPENDIX C. BASIC ISSUE ITEMS LIST
- Explanation of Columns in the Tabular List of Maintenance and Operating Supplies-Section III
- Section II. BASIC ISSUE ITEMS
- INDEX
- INDEX-continued
- INDEX-continued
- INDEX-continued
- INDEX-continued
- INDEX-continued
- INDEX-continued
- INDEX-continued
- The Metric System and Equivalents
- TM-5-4320-258-12
- Shared Top Border
- Distribution
- Blank Page
- Distribution
- Shared Bottom Border
- RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
- Shared Left Border
|