AXIS ASSEMBLY

D. WRTA AND TIRES

a. Removal

1. Block up or provide other support for the pumping assembly.

2. The lug nuts on the muffler side of the unit are removed by turning then clockwise.

3. The lug nuts on the battery side are removed by turning them counterclockwise.

4. Remove both wheels.

b. Inspection - Inspect wheels & tires, & repair or replace any defective parts.

Installation - This proceedure is the reverse of the removal proceedure.

E. AXIS ASSEMBL

a. Removal and Disassembly

1. Block up or provide other support for the pumping assembly.

2. Remove wheels and tires (para. 3-16. D).

3. Refer to Fig. 3-12 and remove and disassemble the axle in the numerical sequence indicated.

b. Cleaning and Inspection

1. Clean all parts with an approved cleaning solvent. Dry thoroughly.

2. Inspect inserts for pitting, grooving, and excessive wear. Inspect springs for cracks, breaks, and loss of tension.

3. Inspect brackets and axle for cracks, breaks and other damage. Replace damaged and missing hardware.

Replace any defective parts.

c. Reassembly and Installation

1. Refer to Fig. 3-12, and reassemble and install the axle assembly.

2. Install the wheels and tires (para. 3-16. D).

3. Remove blocking or other support.