|
|
APPENDIX B
BASIC ISSUE ITEMS LIST
Section I. INTRODUCTION
B-1. Scope
X
Applied to parts and assemblies which are not
This appendix lists items which accompany the John
procured or stocked, the mortality of which
Reiner Centrifugal Pump-Model GP 110-5, or are required
is normally below that of the applicable end
for installation, operation, or operator's maintenance.
item, and the failure of which should result
in retirement of the end item from the
B-2. General
supply system.
This Basic Issue Item List is divided into the following
X1
Applied to repair parts which are not procured
sections:
or stocked, the requirement for which will
a. Basic Issue Items-Section II. This section is a
be supplied by use of the next higher
listing of accessories, repair parts, tools, and publications
assembly or components.
required for operator's maintenance and operation,
X2
Applied to repair parts which are not stocked.
initially issued with, or authorized for the Centrifugal
The indicated maintenance category
Pump Unit.
requiring such repair parts will attempt to
b. Maintenance and Operating Supplies Section III.
obtain them through cannibalization; if not
This section is a listing of maintenance and operating
obtainable through cannibalization, such
supplies required for initial operation.
repair parts will be requisitioned with
supporting justification through normal
supply channels.
B-3. Explanation of Columns
C
Applied to repair parts authorized for local
procurements. If not obtainable from local
The following provides an. explanation of columns in the
procurement, such repair parts will be
tabular list of Basic Issue Items, Section II:
requisitioned through normal supply
channels with a supporting statement of
a. Source, Maintenance, and Recoverability Codes
non-availability from local procurement.
(SMR), Column (1):
G
Applied to Major assemblies that are procured
(1) Source Code indicates the selection status
with PEMA (Procurement Equipment
and source for the listed item. Source codes are:
Missile Army) funds for initial issue only to
be used as exchange assemblies at DSU
and GSU lever or returned to depot supply
Code
Explanation
level.
P
Applied to repair parts which are stocked in or
Note
supplied from GSA/DSA Army supply system,
Source code is not shown on
and authorized for use at indicated
common hardware items known to
maintenance categories.
be readily available in Army supply
M
Applied to repair parts which are not procured
channels
and
through
local
or stocked, but are to be manufactured at
procurement.
indicated maintenance categories.
A
Applied to assemblies which are not procured,
or stocked as such, but made up of two or
(2) Maintenance Code indicates the lowest
more units, each of which carry individual
category of maintenance authorized to install the listed
stock numbers and descriptions and are
item. The maintenance level code is:
procured and stocked and can be assembled
by units at indicated maintenance categories.
B1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |