TM-5-4320-242-14

• OPERATOR, ORGANIZATIONAL DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL PUMP ASSEMBLY, FLAMMABLE LIQUID; BULK TRANSFER; GASOLINE ENGINE DRIVEN; 350-GPM CAPACITY AT 190 FOOT HEAD; WHEEL MOUNTED
• WARNING
• Operator, Organizational, Direct and General Support Maintenance Manual is changed as follows
• Operator, Organizational, Direct and General Support Maintenance Manual is changed as follows
• Section II. INTEGRAL COMPONENTS OF END ITEM
• APPENDIX D. EXPENDABLE SUPPLIES AND MATERIALS LIST
• Operator, Organizational, Direct and General Support Maintenance Manual is changed as follows
• Table of Contents
• Table of Contents-continued
• LIST OF ILLUSTRATIONS
• CHAPTER 1. INTRODUCTION
• Figure 1-1. Pump assembly, right-front, three-quarter view.
• Figure 1-2. Pump assembly, left-rear view.
• Identification and Tabulated Data
• Figure 1-3. Wiring diagram.
• CHAPTER 2. OPERATING INSTRUCTIONS
• Figure 2-1. Controls and instruments (Sheet 2 of 4)
• Figure 2-1. Controls and instruments (Sheet 3 of 4)
• Figure 2-1. Controls and instruments (Sheet 4 of 4)
• Starting
• Figure 2-2. Starting the pump assembly (Sheet 1 of 2)
• Figure 2-2. Starting the pump assembly (Sheet 2 of 2)
• Figure 2-3. Stopping the pump assembly (Sheet 1 of 2)
• Figure 2-3. Stopping the pump assembly (Sheet 2 of 2)
• Operation Under Usual Conditions
• Section II. OPERATION UNDER UNUSUAL CONDITIONS
• Operation in Dusty or Sandy Areas
• CHAPTER 3. OPERATOR / CREW MAINTENANCE INSTRUCTIONS
• Figure 3-1. Lubrication chart.
• Section II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
• Section III. TROUBLESHOOTING
• Section IV. MAINTENANCE OF FUEL TANK CAP AND STRAINER
• CHAPTER 4. ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
• Section II. MOVEMENT TO NEW WORKSITE
• Section V. TROUBLESHOOTING
• Section VII. FUEL SYSTEM
• Figure 4-1. Fuel tank and fuel lines, removal and installation.
• Figure 4-2. Fuel filter, removal and installation Model 84C15-4A084. (Sheet 1 of 2).
• Section VIII. GAGES AND PANEL
• Figure 4-3. Throttle cable, removal and installation. (Sheet 1 of 2).
• Figure 4-3. Throttle cable, removal and installation. (Sheet 2 of 2).
• Starting Switch
• Figure 4-4. Gages and panel, removal and installation. (Sheet 2 of 2).
• Section IX. PUMP ASSEMBLY
• Air Eliminator Assembly
• Figure 4-6. Air eliminator, removal and installation.
• Figure 4-7. Air eliminator, exploded view.
• Discharge and Suction Gate Valves
• Section X. TRAILER ASSEMBLY
• Pintle Hook
• Reflector
• Toolbox and Battery Box
• Figure 4-13. Toolbox and battery box, removal and installation.
• Wheel and Tire Assembly
• Axle Assembly
• Lifting Frame Assembly
• Pulley and Muffler Guard
• Figure 4-18. Pulley and muffler guard, removal and installation.
• CHAPTER 5. DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
• Figure 5-1. Suction manifold and strainer body assembly
• Figure 5-1. Suction manifold and strainer body assembly, removal and installation
• Discharge Manifold, Elbow, and Check Valve
• Installation
• Figure 5-3. Engine, removal and installation (Sheet 1 of 2).
• Pump
• Trailer Assembly
• CHAPTER 6. REPAIR OF PUMP ASSEMBLY
• Intermediate Housing
• Volute Casing
• Suction and Discharge Gate Valves
• Figure 6-2. Suction and discharge gate valves, exploded view Model 84C15-4A084
• Discharge Check Valve
• Figure 6-3. Discharge check valve, exploded view.
• Suction Strainer Assembly
• APPENDIX A. REFERENCES
• APPENDIX B. BASIC ISSUE ITEMS LIST AND ITEMS TROOP INSTALLED OR AUTHORIZED
• APPENDIX C. MAINTENANCE ALLOCATION CHART
• Section II. MAINTENANCE ALLOCATION CHART
• Section IV. REMARKS
• INDEX
• The Metric System and Equivalents
• TM-5-4320-242-14
• Shared Top Border
• Distribution
• Blank Page
• DISTRIBUTION
• Shared Bottom Border
• RECOMMENDED CHANGES TO EQUIPMENT TECHNICAL PUBLICATIONS
• Distribution
• Shared Left Border

Privacy Statement - Press Release - Copyright Information. - Contact Us