SECTION I. INTRODUCTION - TM-5-4320-240-25P0008

TM 5-4320-240-25P

SECTION I

INTRODUCTION

3. Explanation of Columns

1. Scope

The following provides an explanation of columns in the

This manual lists repair parts and special tools required

tabular lists in sections II through VI.

for the performance of organizational, direct support,

a. Source, Maintenance, and Recoverability Codes

general support, and depot maintenance of the pump.

(SMR).

2. General

Note. Common hardware items known to be

a. The repair parts list is arranged as follows:

readily available in Army supply channels will be as-

(1) Individual parts and major assemblies are

signed Maintenance codes only. Source codes, Re-

listed alphabetically by item name within the numbered

coverability codes, and Maintenance Allowances will not

functional groups.

be assigned to this category.

(2) Assembly components and subassemblies are

indented and listed alphabetically by item name under

(1) Source Code. Indicates the selection status

major assemblies.

and source for the listed item. Source codes used are:

b. This Repair Parts and Special Tools List is divided

into the following sections:

Code

Explanation

(1) Prescribed Load Allowance (PLA) Section II. A

P Applied to repair parts which are stocked in or

consolidated listing of repair parts quantitatively

supplied from DSA/GSA or Army supply

allocated for initial stockage at the organizational level.

system, and authorized for use at indicated

This is a mandatory minimum stockage allowance.

categories.

(2) Special Tools, Test and Support Equipment-

Applied to repair parts which are not procured

Section III. No special tools or test and support

or stocked but are to be manufactured at

equipment required for the performance of maintenance

indicated maintenance categories.

at the organizational level.

(3) Repair Parts-Section IV. A list of repair parts

Applied to assemblies which are not procured

authorized for the performance of maintenance at the

or stocked as such but made up of two or

organizational level.

more units, each of which carry individual

(4) Repair Parts-Section V. A list of repair parts

stock numbers and descriptions and are

authorized for the performance of maintenance at the

procured and stocked and can be assembled

direct support, general support, and depot level.

by units at indicated maintenance categories.

(5) Special Tools, Test and Support Equipment-

Section VI. No special tools or test and support

Applied to parts and assemblies which are not

equipment required for the performance of maintenance

procured or stocked, the mortality of which is

at the direct support, general support, and depot level.

normally below that of the applicable end

(6) Federal Stock Number and Reference Number

item, and the failure of which should result in

Index-Section VII. A list of Federal stock numbers

retirement of the end item from the supply

followed by reference numbers, appearing in all the

system.

listings, in ascending alpha-numeric sequence cross-

referenced to index number.