SECTION I. INTRODUCTION - TM-5-4320-225-35P0008

SECTION I

INTRODUCTION

Code

Explanation

Scope

Applied to repair parts which are not procured or

This manual lists repair parts and special tools

stocked but are to be manufactured at indicated

required for the performance of direct support, general

maintenance categories.

support, and depot maintenance of the pump.

Applied to assemblies which are not procured or

stocked as such but made up of two or more

General

units, each of which carry individual stock

numbers and descriptions and are procured

The repair parts list is arranged as follows:

and stocked and can be assembled by units at

indicated maintenance categories.

(1) Individual parts and major assemblies

Applied to parts and assemblies which are not

are listed alphabetically by item name within the

procured or stocked. the mortality of which is

normally below that of the applicable end item,

numbered functional groups.

and the failure of which should result in

retirement of the end item from the supply

(2) Assembly

components

and

system.

subassemblies are indented and listed alphabetically by

Applied to repair parts which are not procured or

item name under major assemblies.

stocked, the requirement for which will he

supplied by use of the next higher assembly or

This Repair Parts and Special Tools List is

components.

divided into the following sections:

Applied to repair parts which are not stocked. The

indicated maintenance category requiring such

(1) Repair Parts - Section II. A list of repair

repair parts will attempt to obtain them through

parts authorized for the performance of maintenance at

cannibalization; if not obtainable through

cannibalization.

such repair parts will he

the direct support, general support, and depot level.

requisitioned with supporting justification

through normal supply channels.

(2) Special Tools, Test and Support

Applied to repair parts authorized for local

Equipment - Section III. A list of special tools, test and

procurements. If not obtainable from local

support equipment authorized for the performance of

procurement, such repair parts will be

maintenance at the direct support, general support, and

requisitioned through normal supply channels

depot level (not applicable).

with a supporting statement of nonavailability

from local procurement.

(3) Federal Stock Number and Reference

Applied to major assemblies that are procured with

Number Index - Section IV. A list of Federal stock

PEMA (Procurement Equipment Missile Army)

funds for initial issue only to be used as

numbers followed by reference numbers in ascending

exchange assemblies at DSU and GSU

alpha-numeric sequence cross-referenced to index

maintenance level. These assemblies will not

number.

be stocked above DSU and GSU level or

returned to depot supply level.

Explanation of columns

Note

The following provides an explanation of columns in the

tabular lists in sections II and III:

Source code is not shown on common

hardware items known to be readily

Source, Maintenance, and Recoverability

available in Army supply channels and

Codes (SMR), Columns (1):

through local procurement.

(1) Source Code, indicates the selection

(2) Maintenance Code, indicates the lowest

status and source for the listed item. Source codes

category of maintenance authorized to install the listed

used are:

item. The maintenance level codes are:

Code

Explanation

Code

Explanation

Applied to repair parts which are stocked in or

Organizational maintenance

supplied from DSA/GSA or Army supply

Direct support maintenance

system, and authorized for use at indicated

General support maintenance

maintenance categories.

Depot maintenance

iii