|
| |
SECTION II - EQUIPMENT DATA
2-4 General Equipment Information
The TPT is made up of both Government and contractor supplied equipment, piping, hose, valves, and fittings.
Government furnished equipment is marked with GFE after the NSN. This section covers design data and other
information on all equipment except the piping, hose, valves, and fittings which will be covered in detail in Section III.
Section IV will describe the systems made up of the equipment and materials described in Section II and III. Data on the
equipment is covered in detail; or the equipment is described in more general terms giving essential and primary
information with reference being made to other specific technical manuals as required.
2-4.1
5,000 Bbl Fabric Collapsible Tanks (18 units)
NSN 5430-01-160-3528 GFE
a.
General Description. The 5000 barrel capacity, fabric collapsible, fuel storage tanks are complete with fittings,
accessories and emergency repair items. An assembled tank consists of the basic tank structure fabricated of
elastomeric-coated nylon fabric with attached handles, filler discharge assemblies with access doors, a vent fitting with
pressure relief cap, and two drain fittings. See Fig. 2-11 for dimensional data and the location of tank fittings.
Dimensions and Design Data
Dimensions Dry:
68 ft. 6 in. x 68 ft. 6 in. (collapsed)
Dimensions Full:
66 ft. x 66 ft. x 6 ft. 8 in. (Ht.)
Design Capacity:
5000 Bbl (210,000 gal.)
Design Pressure:
Designed and intended for static liquid head
(pressure) only. Relief cap on 2 in. vent set
at 3 in. of water (0.1 psig)
b.
Accessories. Each tank is provided with the following accessories:
1)
One 1-foot length hose assembly conforming to MIL-H-370, type I (without static wire), size 1 (1/2-inch),
class 2 fittings with 1/2-inch NPT threads, attached to a 1/2-inch rising stem gate valve conforming to W-V-
54, type II, class A.
2)
Four 1-foot-length hose assemblies conforming to MIL-H-370, type II, size 10 (6-inch), class 1, style A.
3)
A flanged gate valve with two flange gaskets conforming to MIL-V-58039, size 6 inch, type 1, bolted to
quick-disconnect couplings MS27023-19 and M52702719. Bolts, nuts and lock-washers and flat washers
shall be used conforming to MS90725-63, MS51967-8, MS35338-46 and MS27183-14, respectively. Flat
washers are placed under each bolthead and lockwashers under each nut. A cap and plug conforming to
MS27028-19 and MS27029-19 are attached to the valve assembly.
4)
Two -inch tee aluminum assemblies, with one female quick-disconnect coupling on one of the straight run
sections of the tee and male quick disconnect couplings on the opposite end and on the leg of the tee.
Two caps and one plug are provided and attached to the assembly.
2-16
|
