Special Information - TM-10-7200-200-130012

and characteristics of the item by means of its

h. Quantity Incorporated. in Unit. Indicates the

engineering drawings, specifications standards, and

quantity of the item used in the breakout shown on

the illustration figure, which is prepared for an

inspection requirements to identify an item or range

of items.

assembly group or an assembly. A "V" appearing in

NOTE

this column in lieu of a quantity indicates that no

When a stock numbered item is requisitioned, the

specific quantity is applicable. e.g., shims, spacers,

repair part received may have a different part

etc.

number than the part being replaced.

1-12. Special Information

e. Federal Supply Code for Manufacturer (FSCM).

a. The basis of issue for authorized special tools,

The FSCM is a 5-digit numeric code listed in SB

test, and support equipment is the number of end

70842 which is used to identify the manufacturer,

items of equipment supported and the number of

distributor, or Government agency, etc.

maintenance personnel allocated to perform the

required maintenance operations.

f. Description. Indicates the Federal item name

b. Parts which require manufacture or assembly of

and, if required, a minimum description to identify

a maintenance level higher than that authorized for

the item. Items that are included in kits and sets are

installation will indicate in the source column the

listed below the name of the kit or set with quantity

higher maintenance level.

of each item in the kit or set indicated in front of the

c. Repair parts kits and gasket sets appear as the

item name.

last entries in the repair parts listing for the group or

g. Unit of Measure (U/M). Indicates the standard or

assembly to which they apply.

basic quantity by which the listed item is used

1-13. How to Locate Repair Parts

in performing the actual maintenance function. This

Due to the limited number of repair parts, detailed

measure is expressed by a two-character alphabeti-

instructions on how to locate repair parts are not

cal abbreviation, e.g., ea, in., pr, etc., and is the basis

required. To locate repair parts refer to the Repair

used to indicate quantities and allowances in

subsequent columns.

Parts Listing in each chapter.

1-4