| |
TM 10-6630-247-13&P
4-15. LEGSUPPORTREPAIR-cont.
g.
Installation. Refer to figure 4-9.
l
l
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(8)
NOTES
Installation of one leg support is shown. Installation of the other leg
support is similar,
Ensure that all parts identified as mandatory replacement parts are
discarded and replaced with new components.
Position leg support (2) on cabinet (1) with ends of legs (9) in brackets (10).
NOTE
Pivot pins can only be installed from outside of cabinet.
Push pivot pin (8) through bracket (10) and into leg (9). Make sure pivot pin extends
through both ends of bracket.
Install flat washer (5) and cotter pin (4) on end of pivot pin (8).
Install flat washer (7) and cotter pin (6) on other end pivot pin (8).
Position end of brace (15) on angle (16) and aline mounting holes.
Install two screws (14), flat washers (13), lockwashers (12) and nuts ( 11) on brace ( 15).
Repeat steps (2) through (6) for other side leg support (2).
Extend leg supports (2) and (3) and lock braces (15).
Carefully stand cabinet (1) right-side-up.
4-22
|