|
| |
TM 10-6630-247-13&P
4-15. LEG SUPPORT REPAIR - cont.
b.
Disassembly. Refer to figure 4-8.
NOTES
l Removal of one brace is shown. The other is similar.
l Ensure that all parts identified as mandatory replacement parts are
discarded and replaced with new components.
(1)
Remove three nuts (l), lockwashers (2), flat washers (3) and screws (4) from brace (5).
(2) Separate brace (5) from support frame (11).
NOTE
Removal of one barrel bolt is shown. The other is similar.
(3) Remove four nuts (6), lockwashers (7), flat washers (8), screws (9) and barrel
bolt (10) from support frame (11).
c.
Cleaning. Refer to figure 4-8,
Using wiping rag, remove dirt, grease and oil deposits from support frame (11), braces (5) and
barrel bolts (10).
d.
Inspection. Refer to figure 4-8.
(1)
Inspect support frame (11) for cracks, broken welds and bent or twisted frame components.
(2)
Inspect braces (5) for bent or twisted components.
(3)
Inspect barrel bolts (10) for cracks and stuck lock bolt.
e.
Repair. Red-damaged or defective components.
f.
Assembly. Refer to figure 4-8.
NOTES
l Installation of one barrel bolt is shown. The other is similar.
l Ensure that all parts identified as mandatory replacement parts are
discarded and replaced with new components.
(1) Install barrel bolt (10), four screws (9), flat washers (8), lockwashers (7) and nuts (6) on
support frame (11).
NOTE
Installation of one brace is shown. The other is similar.
(2)
Position brace (5) on support frame (11).
(3)
Install three screws (4), flat washere (3), lockwashers (2) and nuts (1) in brace (5).
4-20
|
