|
| |
TM 10-6630-247-13&P
4-15. LEG SUPPORT REPAIR.
This task consists of
a. Removal
b. Disassembly
c. Cleaning
d. Inspection
e. Repair
f. Assembly -
g. Installation
INITIAL SET-UP:
Tools:
Material/Parts:
General Mechanics Tool Kit (App B, Sec III,
Lockwashers (18) (Item 1, App J)
Item 1)
Cotter Pins (8) (Item 2, App J)
Equipment Condition:
Wiping Rags (Item 2, App F)
All components removed from kit
NOTE
Ensure that all parts identified as mandatory replacement parts are discarded
and replaced with new components.
a.
Removal. Refer to figure 4-7.
CAUTION
To prevent damage to cabinet, make sure all components are removed and
both doors and work top are securely fastened before laying cabinet down.
NOTE
Removal of one leg support is shown. Removal of the other leg support is
similar.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Carefully lay cabinet (1) on its back.
Remove cotter pin (4) and flat washer (5) from pivot pin (8).
Remove cotter pin (6) and flat washer (7) from other end of pivot pin (8).
NOTE
Pivot pins can only be removed from outside of cabinet.
Push out pivot pin (8) from leg (9) and bracket (10).
Remove two nuts (11), lockwashers (12), flat washers (13) and screws (14) from brace (15).
Separate brace (15) from angle (16).
Repeat steps (2) through (6) for other side of leg support (2).
Remove leg support (2) from cabinet (1).
4-18
|
