|
| |
TM 10-6630-247-13&P
4-16. CABINET REPAIR - cont.
(42) Place catch (3) on stem of latch (7). Catch must be point in the same direction as the arrow
on latch (7).
(43) Install starwasher (2) and nut (1) on stem of latch (7).
(44) Close panel (12).
Right Cabinet Door Dividers and Lock. Refer to figure 4-16.
(45)
(46)
(47)
(48)
(49)
(50)
(51)
(52)
(53)
(54)
(55)
(56)
Install nameplate (20) on cabinet door (21) with four rivets (19).
Turn handle on lock plate (13) to the right and place lock plate on front of cabinet
door (21). Make sure lock plate is positioned with handle as shown.
Slide support guides (15) over ends of rods (16 and 17).
Connect rods (16 and 17) to back of lock plate (13) as shown.
Turn handle and lock plate (13) as required so that retaining plate (18) secures rods (16
and 17) in place and rods extend through holes in top and bottom of cabinet door (21).
Aline lower support guide (15) with mounting holes in cabinet door (21). Secure guide to
cabinet with two rivets (14). Repeat for upper support guide.
Aline rivet holes in lock plate (13) with rivet holes in cabinet door (21). Install lock plate
(13) on cabinet door (21) with ten rivets (12).
If removed, apply adhesive to bottom of wooden supports (10 and 11). Position supports on
divider (9) and press in place.
Apply adhesive to bottom of divider (9). Position divider in cabinet door (21).
Apply adhesive to to backs of dividers (7 and 8). Position divider in cabinet door (21).
Apply adhesive to left, right and rear edges of divider (6). Position divider in cabinet
door (21) and press in place on top of dividers (7 and 8).
Apply adhesive to top, bottom and rear edges of divider (5). Position divider (5) in cabinet
door (21).
4-40
|
