|
| |
TM 10-6630-247-13&P
4-16. CABINET REPAIR - cont.
(22)
(23)
(24)
(25)
(26)
(27)
(28)
Install strap loop (13) on cabinet (43) with two rivets (12).
Install strap loop (11) on cabinet (43) with two rivets (10).
Connect chains (8) to quick release pins (9) with chain hooks (7).
Connect chains (8) to base of cabinet (43) with chain hooks (7).
Position top (5) on cabinet (43) and aline rivet holes. Install 22 rivets (6) to secure top to
cabinet (43).
Install strike (4) on top (5) with two rivets (3).
Install clasp (2) on top (5) with two rivets (1).
LEFT CABINET DOOR. Refer to figure 4-15.
(29)
(30)
(31)
(32)
(33)
(34)
(35)
(36)
(37)
(38)
(39)
(40)
(41)
Position handle (21) on cabinet door (22) as shown. Aline rivet holes.
Install handle (21) on cabinet (43) with ten rivets (20).
Apply adhesive to back of foam (19). Position foam on cabinet door (22) and press in place.
Apply adhesive to left, right and rear edges of divider (18). Position divider in cabinet
door (22).
Using No. 42 (3/32) drill bit, drill two pilot holes in divider (18) using holes in cabinet door
as a template. Install two screws (17) through cabinet door (22) and into divider.
Apply adhesive to back of foam (16), Position foam on cabinet door (22) and press in place,
Apply adhesive to back of foam sheets (13 and 14). Position foam sheets on divider (15)
and press in place.
Apply adhesive to back of foam (11). Position foam on panel (12) and press in place.
Connect chain hooks (8 and 9) to chain (10).
Connect chain hook (8) to panel (12) and chain hook (9) to cabinet door (22).
Position latch (7) in panel (12). Install nut (6) on latch until handtight.
Rotate latch (7) until arrow on latch knob is pointing toward top of panel (12), then
tighten nut (6).
Install nut (5) and starwasher (4) on stem of latch (7).
4-38
|
