|
| |
TM 10-6630-247-13&P
4-16. CABINET REPAIR - cont.
(5)
Repeat steps (1) through (4) for handle on other side of cabinet (43).
CABINET. Refer to figure 4-14.
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
Install two clips (38) on cabinet (43) with two rivets (37).
Apply adhesive to back of foam sheet (36). Position foam sheet between two clips (38) and
press in place.
Install strap loop (35) on cabinet (43) with two rivets (34).
Position handle (33) on cabinet (43). Make sure handle is right-side-up, as shown.
Install handle (33) on cabinet (43) with 14 rivets (32).
Repeat steps (9) and (10) for handle on other side of cabinet (43).
Install clip (31) on cabinet (43) with two rivets (30).
Apply adhesive to back of pile strip (29). Position pile strip on pan (19) and press in place.
Install strap (28) on cabinet (43) with two rivets ( 27).
Apply adhesive to back of foam sheet (26). Position foam sheet on side of cabinet (43) and
press in place.
Apply adhesive to back of foam sheet (25). Position foam sheet on front of cabinet (43)
and press in place.
Apply adhesive to foam sheet (23). Position foam sheet under pan (24) and press in place.
Apply adhesive to foam sheets ( 21 and 22). Position foam sheets in pan (24) and press in
place.
(19) Apply adhesive to four foam sheets (18) and foam sheet (20). Position foam sheets (18) on pan (19)
and press in place.
(20) Install two clips (17) on cabinet (43) with two rivets (16).
(21) Install strap loop (15) on cabinet (43) with two rivets (14).
4-35
|
