|
| |
TM 10-5430-242-12&P
0005 00
0005 00-21
Change 1
w. 6th Fold: Fold entire lower edge of package up and on top of upper edge of package. Package
measures approximately 4 feet, 7 inches (1.397 m) in width, and 5 feet, 4 inches (1.626 m) in
length.
6. Slide webbing strips under tank from either side, adjusting until strips are 18 inches (45.72 cm) from
the edges of the tank package.
7. Lift tank from the right edge by looping the webbing over lifting device.
8. Lower folded tank package into box from backside of box (markings and address label are on front
side). Tank should be situated in box such that it is flush with front edge, leaving a 4-inch (10.16-m)
gap in the back (into which hoses will be placed).
Refer to Equipment Data (WP 0002 00) for folded dimensions desired.
PACKING AND FOLDING INSTRUCTIONS: 3K, 10K, 20K and 50K GALLON BERM LINER
1. Lay the berm liner flat. Apply cushioning material to drain fittings:
a. Lift up one of the corners of the berm liner with a drain decal and flip over to expose drain fitting.
There are two drain decals.
b. Disconnect drain hose and connect dust cap.
c. Wrap drain fitting with the permanently attached cushioning material and secure with pressure
sensitive tape (Item 3, WP 0042 00).
d. Lay the corner back so that berm liner is flat. Pick up the corner of berm liner with a drain decal
to uncover second drain fitting. Repeat steps 2b and 2c.
2. Berm liner is now ready for folding. Orient yourself to the berm liner: Stand facing the long side of the
berm liner. Berm liner is folded wig-wag, as follows:
3.
a. 1st Fold: Start with the left edge of the berm liner. Lift up the long side of the berm liner closest to
you, and fold 40" from center.
L
R
|
