|
| |
TM 10-5430-242-12&P
0028 00
0028 00-1
Change 1 – 28 April 2002
OPERATOR AND UNIT MAINTENANCE MANUAL
(INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
COLLAPSIBLE FABRIC TANKS, FUEL STORAGE, 3,000,
10,000, 20,000, AND 50,000 GALLON
FILLER/DISCHARGE ASSEMBLY (RELIANCE AND MPC MODELS)
SERVICE AND REPAIR
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, General Mechanics
Filler/Discharge hose assembly removed
(Item 1, WP 0036 00)
(WP 0022 00)
Torque Wrench (ft-lb)
(Item 3, WP 0036 00)
Mandatory Replacement Parts
Gasket
Materials/Parts
(Item 1, WP 0044 00)
Detergent
Gasket
(Item 6, WP 0042 00)
(Item 12, WP 0044 00)
Dry Cleaning Solvent
Gasket
(Item 7, WP 0042 00)
(Item 13, WP 0044 00)
Rags, Wiping
Lockwasher
(Item 2, WP 0042 00)
(Item 6, WP 0044 00)
Silicone Compound
O-Ring
(Item 10, WP 0042 00)
(Item 11, WP 0044 00)
DISASSEMBLY
CAUTION
Be sure to take off closure plate before removing the flanged adapter. The flanged
adapter is bolted to the closure plate and suction stub. If the flanged adapter is
removed first, the hex head nuts bolted to the suction stub will fall into the tank.
NOTE
The filler/discharge fitting on the discharge end requires a female/male elbow. The
filler/discharge fitting of the fill end requires a female/female elbow.
1. Remove 4-inch elbow (1) by pulling outward on cam-lever arms (2), and lifting elbow (1) from flanged
adapter (3).
2. Remove and discard elbow gasket (4) from inside elbow (1).
3. Remove twenty screws (5) and washers (6) from closure plate (7). Lift closure plate (7) from tank
fitting (8).
4. Remove and discard o-ring (9) from the packing groove located in tank fitting (8).
NOTE
MPC Model Tanks use an additional eight gaskets on the screws for mounting the
suction stub.
5. Remove eight nuts (10), lockwashers (11), screws (12), and gaskets (13) from suction stub (14)
flanged adapter (3), and gasket (15). Discard lockwashers (11), gaskets (13), and gasket (15).
6. Remove and discard gasket (16) from inside dust cap (17).
|
