ASSEMBLY - TM-10-5430-238-12-P0130

TM 10-5430-238-12&P

0027 00

ASSEMBLY

1. Install new gasket (16) into dust cap (17).

2. Install new elbow gasket (4) into elbow (1).

3. Place suction stub (14) on a hard, flat surface with the eight bolt holes positioned up.

4. Position new gaskets (13) over each bolt hole in suction stub (14).

5. Position closure plate (7) on top of gaskets (13), and align the holes.

6. Position new flanged adapter gasket (15) on closure plate (7), and align the holes.

7. Position flanged adapter (3) on gasket (15), and align the holes.

8. Install screws (12) through the holes in flanged adapter (3), and thread screws (12) through until the

ends protrude through suction stub (14).

9. Assemble new lockwashers (11) and nuts (10) to screws (12). Torque the fastening hardware to

30 in-lbs (3.41Nm).

10. Lubricate new o-ring (9) with silicone compound. Position o-ring (9) into the packing groove.

11. Position closure plate (7) and attached components on the tank. Install suction stub (14) through the

opening in the tank, until closure plate (7) contacts tank fitting (8).

NOTE

If the tank is lying completely flat, lift the tank to the closure plate to begin threading the

screws through the tank fitting.

12. Assemble twenty washers (6) onto screws (5). Install screws (5) through closure plate (7) and tank

fitting (8).

13. Torque fastening screws (5) to 30 in-lbs (3.41 Nm).

14. Position elbow (1) on flanged adapter (3), and push cam-lever arms (2) inward, locking elbow (1) to

flanged adapter (3).

END OF WORK PACKAGE

0027 00-3/4 blank