INITIAL ADJUSTMENTS AND ROUTINE CHECKS - TM-10-5430-238-12-P0040

TM 10-5430-238-12&P

0005 00

INITIAL ADJUSTMENTS AND ROUTINE CHECKS

NOTE

If the tank is cut or punctured during any phase of operation, refer to WP 0006 00 for

emergency repair procedures.

1. Position filled sandbag (1) under hose (2) near filler/discharge elbow (3). This support will reduce

stress on tank fitting, the gasket in the hose coupling, and the coupling of filler/discharge elbow (3).

WARNING

Check the placement of all sandbags to see potential leak points in order to

avoid fire hazard. Not checking the positions of sandbags can cause serious

injury or death by fire or explosion.

2. Position other sandbags (1) or wood blocks on the ground near the hose connections so that a faulty

or leaking connection is easier to see, and a fire hazard can be avoided.

3. Inspect the tank to verify the elevated connection setup for easy leak detection.

4. Check drain gate or ball valve (4) to verify that it is in the closed position.

5. Check the vent pipe assembly relief cap (5) to verify freedom of operation.

6. Check the filler/discharge gate, butterfly or ball valve (6) to verify closed position.

Elevated Connections for Easy Leak Detection

0005 00-14