|
| |
TM 10-5430-1232-12&P
Recoverability
Application/Explanation
Codes
D-Reparable item. When beyond lower level repair capability, return to depot. Condemnation and disposal if
item not authorized below depot level.
L-Reparable item. Condemnation and disposal not authorized below specialized repair activity (SRA).
A-Item requires special handling or condemnation procedures because of specific reasons (e.g., precious metal
content, high dollar value, critical material, or hazardous material). Refer to appropriate manuals/directives
for specific instructions.
c. CAGEC (Column (3)). The commercial and Government Entity Code (CAGEC) is a 5-digit numeric code
which is used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
d. PART NUMBER (Column (4)). Indicates the primary number used by the manufacturer, (individual,
company, firm, corporation, or Government activity), which controls the design and characteristics of the item
by means of its engineering drawings, specifications standards, and inspection requirements to identify and
item or range of items.
NOTE: Then you use a NSN to requisition an item, the item received may have a different part number from
the part ordered.
e. DESCRIPTION AND USABLE ON CODE (UOC) (Column (5)). This column includes the following
information:
(1) The Federal item name and, when required, a minimum description to identify the item.
(2) The physical security classification of the item is indicated by the parenthetical entry, e.g., Phy Sec
C1
(C) -Confidential, Phy Sec C1 (S) -Secret, Phy Sec C1 (T)-Top Secret).
(3) Items that are included in kits and sets are listed below the name of the kit or set.
(4) Spare/repair parts that make up an assembled item are listed immediately following the assembled
item line entry.
(5) Part numbers for bulk materials are referenced in this column in the line entry for the item to be
manufactured/fabricated.
(6) When the item is not used with all serial numbers of the same model, the effective serial numbers
are shown on the last line(s) of the description (before UOC).
(7) The usable on code, when applicable (see paragraph C-5, Special Information).
(8) In the Special Tools List section, the basis of issue (BOI) appears as the last line(s) in the entry for
each special tool, special TMDE, and other special support equipment. When density of equipments
supported exceeds density spread indicated in the basis of issue, the total authorization is increased
proportionately.
(9) The statement "END OF FIGURE" appears just below the last item description in Column 5 for a
given figure in both Section II and Section lll.
(10) The indenture, shown as dots appearing before the repair part, indicates that the item is a repair part
of the next higher assemble.
f. QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item used in the
breakout shown on the illustration figure, which is prepared for a functional group, subfunctional group, or an
assembly. A “V" appearing in this column is lieu of a quantity indicates that the quantity is variable and the
quantity may vary from application to application.
Change 1 C-4
|
