|
| |
TM 10-5430-232-12&P
SECTION V
MAINTENANCE PROCEDURES
4-10. GENERAL INSTRUCTIONS Maintenance instructions listed in this section will list resources required,
personnel required, and equipment condition for start of procedure, except as noted below:
(1) Personnel required are listed only if the task requires more than one.
(2) The normal standard equipment condition to start a maintenance task is fuel tank drained and
deflated. EQUIPMENT CONDITION is not listed unless some other
condition is required.
4-11 Vent and Pipe Assembly
This task covers: Repair
Materials/Parts
INITIAL SETUP
Preformed Packing, Appendix D, Sect II
Item 16
Tools
Tool Kit, General Mechanics
Equipment Condition: N/A
Appendix B, Section III, item 1
Torque Wrench
Appendix B Section III, Item 2
Materials Parts
Cleaning solvent, item 1, appendix F
Rags, item 6, appendix F
Silicone compound, item 7, appendix F
REMOVAL (see figure 4-8)
1 Remove eight screws (1) and washers (2) from vent and pipe assembly (3).
2 Lift male flanged adapter (4) from tank fitting (5).
3 Remove preformed packing (6) from packing groove (7) in tank fitting (5).
DISASSEMBLY (see figure 4-8)
1 Disconnect female quick-disconnect coupling (8) from flanged male adapter (4).
a. Pull outward on cam-lever arms (9).
b. Lift female quick-disconnect coupling (8) from flanged male adapter (4).
c. Remove gasket (10).
2 Disconnect female quick-disconnect coupling (8) from vent pipe (11). Turn vent pipe to left until
threads disengage.
4-15
|
