|
| |
TM 10-4930-250-13&P
f. Perform manual engine start.
(1)
Remove acoustic cover, if installed, by unbuckling straps and lifting from pump-engine module.
(2) Disconnect battery cable from engine module.
(3) Unlatch and lower pulley guard.
(4)
Turn upper black start knob to the left until knob touched compression release lever.
(5) Align flywheel to timing mark.
(6) Position decompression lever toward pulley end of engine.
(7) Wind rope on start pulley.
Serious personal injury could result from contact with rotating parts such as the engine pulley. Keep
body well clear of pulley while rotating. Do not allow loose clothing near engine where it may be
caught on rotating parts. Handle pulley guard by sides when raising and keep fingers clear of pulley.
Stay clear of whipping rope. Stay clear of whipping rope. Wear goggles to protect eyes during rope
start.
(8) Pull rope to start engine.
(9) Raise and latch pulley guard.
Equipment damage may occur if the fuel transfer pump is allowed to run dry. When the fuel tansfer
pump primes and moves pumpage, the outlet hose will expand. If the hose remains flat, the fuel
transfer pump has not primed and is running dry.
g. Verify that pump outlet hose pressurizes (hose expands). If hose has not pressurized after two minutes of operation,
shut down system and determine why pump has not primed.
WARNING
valve is
open.
Wear
suitable protectiveclothingand
eye protection
.
h. At
the liquid
fuel
filter-separator,depressand latchopen
the manual
2-16
|
