|
| |
TM 10-4930-250-13&P
(9)
Install rotor (5), rotor key (6), rotor vanes (4), rotor cover gasket (3), and rotor cover (2) in accordance with
paragraph b. steps 11 through 15.
NOTE
When installing line switch, ensure switch lever is in the slot in the switch shaft assembly.
(10)
Attach line switch (31) in switch plate (28) using two screws (33).
(11)
Attach the previously tagged four electrical leads (32) to line switch (31). Ensure lock washer (30) is between
each wire terminal lug and line switch (31). Remove the wire tags.
(12)
Position the switch plate (28) on the motor casting (29) and attach using the six screws (27). Do not over tighten
screws (27).
5-16
|
