|
| |
TM 10-4930-250-13&P
4.8.7 FUELHOSEASSEMBLYREPAIR.
Thistaskconsistsof:
a. Disassembly
b. Inspection
c. Assembly
INITIAL
SET-UP:
Tools:
Materials/Parts Required:
Tool Kit, General Mechanic Automotive
Rag, wiping (Appendix F, Section II, Item 7)
(Appendix B, Section III, Item 1)
Seals (4) (Appendix F, Section If Item 6)
Chemical and Oil Protective Gloves
Strapping (Appendix F, Section II, Item 4)
(Appendix B, Section III, Item 2)
Solvent, Dry Cleaning
Clamping Tool (Appendix B, Section III, Item 3)
(Appendix F, Section II, Item 2)
Goggles (Appendix B, Section III, Item 2)
General Safety Requirements:
Equipment Condition:
Hose removed from system (para. 2.8)
WARNING
Fuels are toxic and flammable. Do not get on person
or clothing. Work in well ventilated area. Do not
smoke. Ensure equipment is well grounded.
NOTE
Ensure that all parts identified as mandatory replacement parts are discarded and replaced with new
components. Disassemble hoses only to the level required to make repairs.
The following procedure applies to all fuel hoses in the AAFARS system.
a. Disassernbl
(Figure 4-7)
Rubber gloves should be worn when handling fueling system componenets due to the toxic effetcs of
some additives.
(1)
Slide rubber sleeve (1) from top of clamps (2 and 3).
(2)
Cut clamps (2 and 3) from hose (4).
(3)
Cut clamps (5 and 6) from hose (4).
(4)
Remove unisex coupling assembly (7) from end of hose (4).
4-19
|
