|
| |
TM 10-4930-250-13&P
b. Assembly.
Rubber gloves should be worn when handling fueling system components due to the toxic effects of
some fuel additives.
(1)
If necessary to install attaching cable (3) on 3-inch unisex coupling dust cap (1), thread attaching cable (3) through
split ring (5) on dust cap (1). If necessary to install attaching cable (3) on 2-inch unisex coupling dust cap (1), thread
attaching cable (3) through dust cap (1) forming a loop. Use a sleeve (6) and crimp loose end of cable to itself.
(2)
Install dust cap (1) and attaching cable (3) to unisex coupling (2) by threading attaching cable (3) through split ring
(4) on unisex coupling (2).
(3) Install dust cap (1) onto unisex coupling (2).
4.8.4
REPLACE UNISEX COUPLING BUMPER. (Refer to figure 4-5.)
This task consists of:
a. Removal
b. Assembly
INITIAL
SET-UP:
Tools:
Materials/Parts Required:
Tool kit, General Mechanic Automotive
None
(Appendix B, Section III, Item 1)
Chemical and Oil Protective Gloves
(Appendix B, Section III, Item 2)
General Safety Requirements:
Equipment Condition:
Coupling removed (para. 4.8.1 or 4.8.2)
WARNING
Fuels are toxic and flammable. Do not get on person
or clothing. Work in well ventilated area. Do not
smoke. Ensure equipment is well grounded.
a.
Removal.
Rubber gloves should be worn when handling fueling system components due to the toxic effects of
some fuel additives.
(1) Remove dust cap (1) from unisex coupling (2).
4-14
|
