|
| |
TM 10-4930-248-13&P
5-2.
CCR
NOZZLE
ASSEMBLY
REPAIR
- continued.
C.
Assembly
- continued.
(23)
Insert
flow guide (26), valve spring (25) and sleeve seal (24) into housing
(17). Push sleeve
seal and valve spring
down with compression
tool until the tool locks onto the collar
(28).
WARNING
During
assembly,
components
are under
spring
pressure,
injury
possible.
If
collar
is pushed/pulled
to the rear,
piston
tool and sleeve will be discharged
under
pressure,
Do not push/pull
the collar
the the rear.
Do not remove
the
piston
removal
tool until
assembly
is complete.
(24)
Install
diaphragm
carrier
wrench
into vise.
Position
square
end of housing
(17) on carrier
wrench
and slowly
turn until
housing
seats itself on wrench.
(25)
Install
poppet
(23) through
compression
tool and tighten
with the poppet
wrench.
Remove
poppet
wrench;
and remove
housing
(17) from diaphragm
carrier
wrench;
remove
carrier
wrench
from vice.
(26)
Check
diaphragm
assembly
(20) for movement
by gently pulling
flow indicator
(22) until
it stops, then release.
(27)
Install
strainer
housing
(38) into housing
(17).
5-14
|
