|
| |
TM 10-4930-248-13&P
5-2.
CCR NOZZLE
ASSEMBLY
REPAIR
- continuted:
C.
Assembly
- continued.
(15)
Place housing
(17), with discharge
end facing up, into a soft face vise and tighten
only
enough
to prevent
housing
from turning
or falling
from vise.
(16)
Aline body wrench
with nine locking lugs and press down until the collar (28) trips in the
forward
position.
CAUTION
To reduce the friction
between
the locking
lugs and the collar,
slightly
pull
back on the collar.
NOTE
Always
aline the slot in the collar and the tab on the housing.
(17)
Tighten
the assembly
to 300 in-lb.
(18)
Pull back on collar (28) to release
the body wrench,
remove
body wrench.
Remove
nozzle
assembly
from vise.
BODY WRENCH
.A@
28
17
ALINE NOTCH
ANDTAB
5-12
|
