|
| |
TM 10-4930-247-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Paragraph
Title
Page
Section I
Lubrication Instructions .................................................................................................
3-1
Section II
Operator Troubleshooting Procedures ............................................................................
3-1
3-1.
Introduction .................................................................................................................
3-1
3-2.
Malfunction Index..........................................................................................................
3-2
3-3.
Troubleshooting Procedures .........................................................................................
3-2
Section III
Operator Maintenance Procedures ................................................................................
3-12
3-4.
Component Replacement .............................................................................................
3-12
3-5.
Dry Break Coupling Repair ...........................................................................................
3-16
Section I. LUBRICATION INSTRUCTIONS
Lubrication of the HTARS is limited to the HEMTT tanker. Lubricate this equipment in accordance with TM 9-2320-279-
10-1.
Section II. OPERATOR TROUBLESHOOTING PROCEDURES
3-1.
INTRODUCTION.
a.
The troubleshooting table lists the common malfunctions which you may find during operation of the HTARS. You
should perform the tests, inspections and corrective actions in the order they appear in the table.
b.
This table cannot list all the malfunctions that may occur, all the tests or inspections needed to find the fault, or all
the corrective actions needed to correct the fault. If the equipment malfunction is not listed or actions listed do not
correct the fault, notify your supervisor.
c.
Refer to TM 9-2320-279-10-1 for troubleshooting malfunctions on the HEMTT tanker.
d.
Refer to TM 10-4930-248-13&P for troubleshooting malfunctions on the CCR nozzle.
3-1
|
