|
| |
TM 10-4930-247-13&P
2-15.
PREPARATION FOR MOVEMENT- cont.
(8)
Disconnect fuel hose (13) from tee (12).
(9)
Disconnect tee (12) from fuel hose (11).
(10)
Disconnect fuel hose (11) from tee (3).
(11)
Disconnect fuel hose (10) from elbow (9).
(12)
Disconnect elbow (9) from fuel hose (8).
(13)
Disconnect two fuel hoses (7 and 8) from tee (5).
(14)
Disconnect fuel hose (6) from tee (5).
(15)
Disconnect tee (5) from fuel hose (4).
(16)
Disconnect fuel hose (4) from tee (3).
(17)
Disconnect tee (3) from fuel hose (1).
(18)
Disconnect quick disconnect end of fuel hose (1) from HEMTT tanker fuel outlet (2).
(19)
Prepare HEMTT tanker for movement in accordance with TM 9-2320-279-10-1.
f.
Rolling Fuel Hoses. Refer to figure 2-22.
NOTES
·
The following instructions apply to all fuel hoses used in the HTARS. Repeat
these procedures for each fuel hose during fuel system disassembly.
·
Hose straps have two loops. One loop is used as a handle to lift and carry
hose; the other loop is wrapped over hose to prevent loss of hose strap.
·
Drain residual fuel from hoses into a suitable container. Dispose of fuel in
accordance with applicable regulations.
(1)
Stretch out fuel hose (1). Remove all twists so that hose lays flat.
(2)
Fold fuel hose (1) in half so that dry break couplings (5 and 6) are positioned at one end of hose.
(3)
Roll fuel hose (1) from folded end to dry break couplings (5 and 6). Keep hose halves alined so that a tight
roll is obtained.
(4)
Position hose strap (3) around rolled fuel hose (1).
(5)
Place tag end of hose strap (3) through bottom of buckle (41, around slide (2) and back out buckle as
shown.
2-49
|
