|
| |
TM 10-4930-245-13&P
5-2.
CCR NOZZLE ASSEMBLY REPAIR - continued.
c.
Assembly - continued.
(23)
Insert flow guide (26), valve spring (25) and sleeve seal (24) into housing (17). Push sleeve seal and
valve spring down with compression tool until the tool locks onto the collar (28).
WARNING
Assembly under spring pressure, injury possible. If collar is pushed/pulled
to the rear, piston tool and sleeve will be discharged under pressure. Do
not push/pull the collar the rear. Do not remove the piston removal tool
until until assembly is complete.
(24)
Install diaphragm carrier wrench into vise. Position square end of housing (17) on carrier wrench and
slowly turn until housing seats itself.
(25)
Install poppet (23) through compression tool and tighten with the poppet wrench. Remove poppet
wrench; and remove nozzle assembly from diaphragm carrier wrench; remove carrier wrench from
vice.
(26)
Check diaphragm assembly (20) for movement by gently pulling flow indicator (22) until it stops, then
release.
(27)
Install strainer housing (38) into housing (17).
5-14
|
