|
| |
TM 10-4930-243-13&P
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Paragraph
Page
Section I.
Lubrication Instructions ....................................................................................................
3-1
Section II.
Operator Troubleshooting.................................................................................................
3-1
3-1.
Introduction ......................................................................................................................
3-1
3-2.
Malfunction Index.............................................................................................................
3-1
3-3.
Troubleshooting ...............................................................................................................
3-2
Section III.
Operator Maintenance Procedures ...................................................................................
3-6
Section I. LUBRICATION INSTRUCTIONS
Lubrication is not required for the arctic CCR nozzle and adapter.
Section II. OPERATOR TROUBLESHOOTING
3-1. INTRODUCTION.
a.
This section contains troubleshooting information for locating and correcting most of the operating trouble which
may develop in the arctic CCR nozzle, adapter and their components. You should perform the tests/inspections
and corrective actions in the order listed.
b. Table 3-1, Malfunction Index, lists the common malfunctions which you may find during operation or
maintenance of the arctic CCR nozzle and adapter or components. Table 3-2. Troubleshooting Procedures lists
the most common malfunctions and each malfunction is followed by a list of tests or inspections which will help
you determine probable causes and corrective actions.
3-2. MALFUNCTION INDEX.
Refer to Table 3-1. Any malfunction requiring repair beyond the scope of the operator should be referred to Unit
Maintenance.
Table 3-1. Malfunction Index
MALFUNCTION
PAGE
1.
Leakage at Discharge End of CCR Nozzle During Refueling ............................................ 3-2
2.
Leakage Between CCR Nozzle Inlet Coupling and Hose .................................................. 3-3
3.
Leakage Between GFA Nozzle and CCR Nozzle.............................................................. 3-4
4.
Inadequate Fuel Flow From GFA Nozzle.......................................................................... 3-5
5.
Ground Cable Fails to Connect to Grounding Receptacle................................................. 3-6
3-1
|
