| |
TM 10-4930-242-13&P
5-2.
D-1 FUELING NOZZLE REPAIR - continued.
NOTE
Make sure packing is seated m the bottom of the groove on inlet elbow.
(14)
If packing (33) and slip ring (32) were removed during disassembly, lubricate packing (33) with silicone
compound and install into groove on inlet elbow (31).
NOTE
The slipring must set on top of the packing installed in step (14).
(15)
Lubricate slipring (32) with silicone compound and install on inlet elbow (31) into the same groove as packing
(33).
(16)
Lubricate packing (34) with silicone compound and install into outer groove in body (47).
NOTE
Use care when installing inlet elbow into body so packing is not cut.
(17)
Install inlet elbow (31) into bottom of nozzle body (47).
CAUTION
Grease on ball bearings makes assembly difficult. DO NOT use any
form of grease on ball bearings
(18)
Insert 39 ball bearings (30) into body (47).
(19)
Lubricate one packing (24) with silicone compound and install on screw (29) and install into nozzle body (47).
5-12
|