|
| |
TM 10-4930-242-13&P
5-2.
D-1 FUELING NOZZLE REPAIR.
This task consists of:
a.
Disassembly
b.
Repair
c.
Assembly
d.
Test
INITIAL SET-UP:
Tools:
Materials/Parts:
General mechanic's tool kit (Item 1, Appendix B)
Cleaning solvent, (Item 1, Appendix F)
Hammer, Soft Head (Item 2, Appendix B)
Rags, Wiping, Item 2, Appendix F)
Vise, Soft Face (Item 2, Appendix B)
Tape, Anti-seize Teflon Item 3, Appendix F)
Wrench, Adjustable 0-3 3/8 Inch (Item 2, Appendix
Silicone Compound (Item 4, Appendix F)
B)
Gloves (Item 5, Appendix F)
Adapter, Pressure (Item 3, Appendix B)
Bumper (Item 1, Appendix H)
Adapter, Bayonet (Item 4, Appendix B)
Bearing, Collar (Item 2, Appendix H)
Adapter, Male (Item 5, Appendix B)
Packing. Preformed (2 each) (Item 3, Appendix H)
Packing, Preformed (Item 4, Appendix H)
Equipment Condition:
Packing, Preformed (Item 5, Appendix H)
Nozzle removed from fueling system (Ref System
Packing, Preformed (Item 6, Appendix H)
T. M.)
Packing. Preformed (Item 9, Appendix H) If removed
during repair
General Safety Requirements:
Lockwashers (Item 7, Appendix H)
Nose Seal (Item 8, Appendix H)
WARNINGS
Gasket, Nozzle (Item 11, Appendix H)
Fuels are toxic and flammable. Do not get fuel on
Slip Ring (Item 10, Appendix H) If removed during
person or clothing. Do not use near open flame. Area
repair.
should be well ventilated.
· Fuel Flammable/Do Not Smoke.
· Using dry cleaning solvents incorrectly can cause
injury or death.
a.
Disassembly.
NOTE
Disassemble nozzle only to the level required to make repairs
(1)
Remove coupling plug (1) from coupling ( 7)
(2)
Remove gasket ( 2) from coupling (7).
(3)
Remove six nuts (3), six lockwashers (4), six flat washers (5), and six screws (6) to remove coupling (7) from
elbow (31).
5-2
|
