| |
TM 10-4930-241-13
2-16. ASSEMBLY AND PREPARATION FOR USE - CONT.
j.
Fuel System 200 GPM Filter-Separators to Fueling Manifold with Five Valves. Refer to figure 2-18.
WARNING
Do not touch surfaces with bare skin. Bare skin will freeze to metal surfaces in subzero temperatures.
Always wear arctic mittens when handling components.
CAUTION
To prevent contamination of fuel system components use care when connecting couplings to avoid getting
metal, ice, snow, dirt, sand and debris on coupling mating surfaces or in hoses during assembly.
NOTES
This covers installation of a typical AFSSP system. You may need to adjust the number of components
used, and their position in the system, to meet your mission requirements.
If required, connect 3-inch male x 3-inch female elbow to water detection assembly.
Refer to para 2-16e for connection of quick disconnect couplings.
(1)
Connect water detection assemblies ( 1, 2 and 3) to output of filter-separator (4,5 and 6).
(2)
Connect 4-inch male x 3-inch female reducers (7,8 and 9) to water detection assemblies (1,2, and 3).
(3)
Connect 25 foot 4-inch collapsible hoses (10,11 and 12) to reducers (7,8 and 9).
(4)
Connect 4-inch male x 4-inch female elbows (13 and 14) to collapsible hoses (10 and 12).
(5)
Connect elbows (13 and 14) to 4-inch fueling manifold (15) with five valves.
(6)
Connect 4-inch collapsible hose (1 l) to 4-inch fueling manifold (15) with five valves.
2-47
|