| |
TM 10-4930-241-13
2-16. ASSEMBLY AND PREPARATION FOR USE - CONT.
i.
Fuel System Secondary 600 GPM Pump Output to Filter-Separators. Refer to figure 2-17.
WARNING
Do not touch surfaces with bare skin. Bare skin will freeze to metal surfaces in subzero temperatures.
Always wear arctic mittens when handling components.
CAUTION
To prevent contamination of fuel system components use care when connecting couplings to avoid getting
metal, ice, snow, dirt, sand and debris on coupling mating surfaces or in hoses during assembly.
NOTES
This covers installation of a typical AFSSP system. You may need to adjust the number of components used, and
their position in the system, to meet your mission requirements.
Refer to para 2-16e for connection of quick disconnect couplings.
There are three 200 GPM filter-separators used in AFSSP.
(1)
Connect together two 25 foot 4-inch collapsible hoses (1).
(2)
Connect one end of the collapsible hoses (1) to secondary 600 GPM pump (2).
(3)
Connect other end of hoses (1) to 4-inch fueling manifold (3) with two valves.
(4)
Connect together two 4-inch collapsible hoses (4).
(5)
Connect one end of collapsible hoses (4) to 4-inch fueling manifold (5) with three valves.
(6)
Connect elbows (6 and 7) to end of fueling manifold (5).
(7)
Connect 4-inch collapsible hoses (8 and 9) to elbows (6 and 7).
(8)
Connect 4-inch collapsible hose (10) to fueling manifold (5).
(9)
Connect 3-inch male x 4-inch female reducers ( 11, 12 and 13) to end of collapsible hoses (8, 9 and 10).
(10)
Connect other end of reducers (ii, 12 and 13) to filter separators (14, 15 and 16).
2-45
|