|
| |
TM 10-4930-241-13
4-14. REDUCER ASSEMBLY (2 IN. M X 3 IN. FEM) REPAIR - cont.
c.
Repair. Replace damaged or defective components.
d.
Assembly. Refer to figure 4-4.
CAUTIONS
* To prevent premature failure of reducer assembly, gaskets certified for arctic service must be installed.
If a new dust cap or reducer has been installed, remove and discard black gaskets supplied with the new
components and replace them with arctic service gaskets.
* Ensure gasket is fully seated in gasket seat of reducer/dust cap to prevent leaks in assembled
components.
(1)
Install gasket (8) in dust cap (9).
(2)
Install dust cap (9) on male end of reducer (10).
(3)
Install gasket (7) in female end of reducer (10).
(4)
Install dust plug (6) in female end of reducer (10).
(5)
Install chains (4 and 5) with split rings (1, 2 and 3).
4-15. REDUCER ASSEMBLY (2 IN. M X 4 IN. FEM) REPAIR.
Refer to para 4-14 to repair the 2-in. M X 4-in. F reducer assembly
4-16
|
