| |
TM 10-4930-241-13
2-18. OPERATING PROCEDURES - CONT.
(4)
Refuel Mode - Fuel Distribution from Fuel Tanks to Off Loading Points. Refer to figure 2-34.
WARNING
Do not touch surfaces with bare skin. Bare skin will freeze to metal
surfaces in subzero temperatures. Always wear arctic mittens when
handling components.
NOTE
Handwheels on fueling manifolds may be opened to allow fuel flow
to fill one, two or three fuel tanks at the same time. Open valves as
needed to support your mission requirements.
The following procedures describes fuel distribution from the
three fuel tanks at the same time to off loading points (refilling,
drum filling and bottom loading).
(a) Ensure gate valves (1 and 2) are closed.
(b) Turn handwheels (3 thru 8) to open position on fueling manifolds.
(c) Ensure gate valves (9 and 10) are closed.
(d) Turn handwheels (11 thru 14) to close positions on fueling manifolds.
(e) Ensure gate valve (15) is closed.
(f)
Turn handwheels (16 thru 19) to open position.
(g) Ensure gate valve (20) is closed.
NOTE
Fuel is now available at the off loading points (refilling, drum and
bottom loading).
(h) Start and operate secondary 600 GPM pump (22). Refer to TM 10-4320-342-10.
(i)
Fill and purge 200 GPM filter separators(21). Refer to TM 10-4330-23613.
(j)
When fueling operations are completed, shut down secondary 600 GPM pump (22).
(k) Close all valves.
2-80
|