|
| |
TM 10-4930-240-13
4-42. STORAGE BOX ASSEMBLY REPAIR-cont.
Refer to figure 4-28.
(10) Remove ten rivets (1), backup plates (2) and pull out lift handles (3) from container (4). . Repeat
step for remaining three lift handles.
(11) Remove two rivets (5), backup plates (6) and latch (7) from container (4). . Repeat step for
remaining three latches.
(12) Remove two rivets (8) and top angle bracket (9) from container (4). . Repeat step for remaining
nine top angle brackets.
(13) Remove two rivets (10) and bottom angle bracket (11) from container (4). Repeat step for
remaining three bottom angle brackets.
(14) Remove twelve rivets (12), backup plates (13) and channels (14) from container (4). Repeat step
for remaining three channels.
(15) Remove twenty rivets (15), backup plates (16) and skid (17) from bottom of container (4). Repeat
step for remaining skid.
Refer to figure 4-29.
(16) Remove sixteen rivets (1), backup plates (2) and corner angle (3) from panels (4 and 5). Repeat
step for remaining three corner angles.
(17) Remove seventeen rivets (9), backup plates (10) and lift out side panel (11) from lower frame (8).
Repeat step for other side panel (4).
(18) Remove fifty four rivets (12), backup plates (13) and lift out bottom panel (14) from lower frame (8).
b. Cleaning.
WARNING
Dry cleaning solvent, P-D-680, Type III, is potentially dangerous to personnel and
equipment. Eye and skin protection is required. Avoid repeated and prolonged
skin contact. Wash hands immediately after exposure. Do not use near open
flame or excessive heat Use only in areas with good ventilation.
Using wiping rags and cleaning solvent, remove dirt and contaminants from all components.
4-80
|
