|
| |
TM 10-4930-240-13
4-42. STORAGE BOX ASSEMBLY REPAIR.
This task covers:
a.
Disassembly
b.
Cleaning
c.
Repair
d.
Assembly
INITIAL SET-UP:
Tools:
Material/Parts:
General Mech Tool Kit (App B, Sect III, Item 1)
Cleaning Solvent
(Item 1, App E)
Drill and Bit Set
(App B, Sect III, Item 2)
Wiping Rag
(Item 2, App E)
Hand Riveter
(App B, Sect III, Item 2)
Adhesive Sealant
(Item 4, App E)
Equipment Condition:
Lockwasher (32)
(Item 7, App J)
Components removed from storage box
Blind Rivet (48)
(Item 9, App J)
Blind Rivet (8)
(Item 13, App J)
NOTE
Ensure that all parts identified as mandatory replacement parts are discarded and
replaced with new components.
a. Disassembly. Refer to figure 4-27.
NOTE
Disassemble storage box only the extent required to replace defective component.
(1) Remove two nuts (1), lockwashers (2), screws (3), and strike (4) from cover. . Repeat for three
remaining strikes.
(2) Remove fifty four rivets (5) and backup plates (6), then separate top panel (7) from upper frame (8).
(3) Remove upper shelf (9) from storage container (10).
(4) Remove lower shelf (11) from storage container (10).
(5) Remove eight rivets (12) and backup plates (13), then separate divider (14) from lower shelf (11).
(6) Slide adapter (15) on webbing and remove strap webbing (16) from container (10). Repeat step for
remaining five strap webbings.
(7) Remove four rivets (17), backup plates (18) and identification plate (19) from container (10).
(8) Remove four rivets (20), backup plates (21) and identification plate (22) from container (10).
(9) Remove two nuts (23), lockwashers (24), screws (25), ring (26) and clip (27) from storage container
(10). . Repeat step for remaining three rings
4-78
|
