|
| |
TM 10-4930-240-13
4-26. EXHAUST DEFLECTOR ASSEMBLY REPAIR - cont.
This task consists of.
a. Disassembly
b.
Cleaning
c.
Repair
d.
Assembly
INITIAL SET-UP:
Tools:
Material/Parts:
General Mech Tool Kit (App B, Sect III, Item 1)
Cleaning Solvent
(Item 1, App E)
Drill and Bit Set (App B, Sect III, Item 2)
Wiping Rag
(Item 2, App E)
Hand Riveter
(App B, Sect III, Item 2)
Blind Rivet
(Item 23, App J)
Equipment Condition :
Blind Rivet (8)
(Item 24, App J)
Exhaust deflector assembly
Lockwasher (8)
(Item 25, App J)
removed from pump (para 2-20)
NOTE
Ensure that all parts identified as mandatory replacement parts are
discarded and replaced with new components.
a.
Disassembly. Refer to figure 4-17.
NOTE
Disassemble exhaust deflector assembly only the extent required to replace
defective component.
(1)
Remove rivet (1) and pin (2) from deflector (3).
(2)
Slide vent (4) from deflector (3).
(3)
Remove eight nuts (5), lockwashers (6) and screws (7) from frame (8) and separate deflector (3)
from upper frame (8).
(4)
-Remove four rivets (9) and pins (10) from lower frame (21).
(5)
Remove two rivets (11) and pins (12) from two angle braces (13).
(6)
Remove two nuts (14), screws (15) and nuts (16) from lower frame (21).
(7)
Remove two nuts (17) and locators (18) from lower frame (21).
(8)
Remove two bolts (19) and nuts (20) from locators (18).
4-50
|
